GPU Support ice and Case Decoration

Covid boredom led me to this design. :p
And it's subject to change, hence, why I didn't hide the extra LEDs sticking out.

I started by needing a graphics card support for the sag. This is 80mm tall when put together, so add or subtract height as you need for yours.

There are large and small for both the top part of the case and the GPU support.
You will need to print the GPU_TOP twice for the large.

There's also a tunnel built in the large support so you can run an LED strip for lights.
It's hard to tell from the video, but it makes it look a lot cooler, in my opinion.

I also threw in the Gears COG for some added flare.


I only used Cura supports on the large GPU support to keep the light tunnel from collapsing.

Zero infill % on the ceiling piece, 10% on everything else.
I used two small screws to hold the ceiling pieces on through the fan mount area on the case.