Thingiverse
GR8 PI2 ( Raspberry PI case )
von Tripnutz
349
Downloads
281
Likes
6
Makes
Hi again!
Bringing to you my next version of the GR8 PI Case Version 2.
I had a bunch of feedback and a request to " take the air out" of the last design. So I have created a shorter more symmetrical version. This version is about 1.5" shorter than the original version. This version can only house a 10mm thick 80mm x 80mm fan. I have found most of these to be 5v x .3a so it is a little less stress on the Pi power as well. And as always, you don't have to run a fan in this but that was what started it for me so I decided to just build off that.
This case is completely snap together when I printed it but I did leave some spots for hardware if you would like to mount it all together.
Enjoy! Feel free to add some feedback and I would love to see some pics of your makes!
Bringing to you my next version of the GR8 PI Case Version 2.
I had a bunch of feedback and a request to " take the air out" of the last design. So I have created a shorter more symmetrical version. This version is about 1.5" shorter than the original version. This version can only house a 10mm thick 80mm x 80mm fan. I have found most of these to be 5v x .3a so it is a little less stress on the Pi power as well. And as always, you don't have to run a fan in this but that was what started it for me so I decided to just build off that.
This case is completely snap together when I printed it but I did leave some spots for hardware if you would like to mount it all together.
Enjoy! Feel free to add some feedback and I would love to see some pics of your makes!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
