Grab-Ons

This is my entry into the Monitor Riser competition but it is also the first showing of the corner clamp system we call Grab-Ons. The clamps work with plywood between 9mm and 12mm (3/8 & ½ inch for those in the US). The clamps are available in 90, 60 & 45 degree versions to create cubes, hexagons & octagons… the only limit is your imagination. And, when you're done, they are easy to take apart so great for temporary displays & shelving. The clamps are held together with M6x25mm cap head screws and nuts, so the only tool needed is a 5mm Allen Key (hex wrench). To assemble to clamps onto the ply, simply assemble finger tight. Then when everything is in the correct location tighten all the screws to hold in place. It's important to not overtighten the clamps as excessive pressure could break the clamps. To construct the monitor riser shown, you will need:4 x 90-degree clamps4 x 60-degree clamps8 x screws & nuts as above5mm Allen Key Plus the plywood cut as follows (9 or 12mm is fi