Thingiverse
Graflex Stand
von Crypnox
11
Downloads
10
Likes
0
Makes
This is a Displaystand for your Graflex Lightsaber.
I printed it in Anycubic Black PLA in 0.16mm Layerheight.
It took about 27 hours that way but it turned out great.
The Aurebesh letters say "Graflex" as you could have guessed.
i printed it laying on its "back" with the Tree supports in Cura. That way i can print the holderarms without support and only have to support the top of the letters.
The print is rather PLA consuming so check your settings properly before printing.
Mine was using about ~350 grams of PLA
I printed it in Anycubic Black PLA in 0.16mm Layerheight.
It took about 27 hours that way but it turned out great.
The Aurebesh letters say "Graflex" as you could have guessed.
i printed it laying on its "back" with the Tree supports in Cura. That way i can print the holderarms without support and only have to support the top of the letters.
The print is rather PLA consuming so check your settings properly before printing.
Mine was using about ~350 grams of PLA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!