Graphic Tablet Holder

· Easy to print (no supports required), straightforward graphic tablet holder

· Easy installation: print 1x short piece and 2x long piece.
Fit the pieces to your graphics tablet (short pieces to the with of it and the two long pieces to the sides.
Place the tablet under the table on the spot you want to keep it, and mark where the screws will go.
Use 6x M3.5 screws to install the pieces.
Done! Graphic tablet can slide in and out!

· Short piece: 12cm long

· Long piece: 20cm long

· Works ideally with a 'ugee m708', but would work too with other similarly sized tablets.

I use it to keep my graphic tablet. I printed it for myself but I hope you can too find it useful.
Thanks! :D