Grasshopper Drone

My second attempt at a DIY drone from scratch.
Printed in Fluorescent yellow pla.
Use support to buildplate for GPS and body.
Weighs 1274g, so not light, but the motors can take it.
I may change the legs as they give a hard landing.

Parts list:

PLA fluorescent yellow - £9.99 ebay
Kakute F4 v2 AIO - £32 banggood
920 kv 2212 motors x 4 £17 amazon
ESC 20A x 4 - £20 banggood
Flysky rxtx fs-i6s fs-1a10b
Props 1045 dji shaft x 4 £5 banggood
Skyzone FPV kit - £250 gearbest
3300mah 3s lipo - (was £19) £28 Amazon (https://www.amazon.co.uk/gp/product/B0113JGZ1O/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1)
GPS betian 880 with mag - £13 Banggood
Lipo charger - £5 banggood
Aomway antenna 5.8ghz x 2 - £10 banggood
8 x m3x30mm screws
12 x m3 locknuts
4 x m3x10mm screws
4 x m3x5mm screws
40mm fan and heatsink - fan was stolen from my anet a8 extruder, heatsink was found in an old amplifier.
Sticky felt pads.
Cable ties.
INAV software.
Foam for underneath the FC to dampen t