Grater handle

My Wife broke the original one so I need to design and print a new one. To improve the mechanical strength of the screw connection I propose to print in 15 degree angle from the table- as on last picture. For proper mount you need 4 pcs of 2,5mm screws.

Handle 0,2 or 0,24 layer height and 20-40% infil. Use more than 3 top and bottom layers because the angles are very high and you may see the infill through the top and bottom layers.
Holders x4 0,12 layer height and I use 80% infil

Please be careful during support removal.

Parts designed in Solid Edge ST6