Thingiverse
GraviDispenser
door Schleifi123
81
Downloads
35
Likes
1
Makes
A marble dispenser for Gravitrax. The beaker can hold about 30 marbles. If it's full, you run a good chance that the marbles block each other and you need a brief stir.
There a two versions:
Version 1 uses a spring ("Feder") which must be printed with TPU (I used 98D). The spring is inserted from the top with the "double-bar" down.
Version 2 is an all-PLA print. The sprind is inserted into the two little slits left and right down from the marble outlet.
The buttom ring can be found eg here: https://www.thingiverse.com/thing:4900813
There a two versions:
Version 1 uses a spring ("Feder") which must be printed with TPU (I used 98D). The spring is inserted from the top with the "double-bar" down.
Version 2 is an all-PLA print. The sprind is inserted into the two little slits left and right down from the marble outlet.
The buttom ring can be found eg here: https://www.thingiverse.com/thing:4900813
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
