Thingiverse
Gravitrax column variable
von Fredle1957
52
Downloads
31
Likes
0
Makes
ATTENTION!: I design Gravitrax parts and extensions that are not for sale.
The height stone consists of 3 parts, the plate at the bottom (Platte unten), the plate at the top (Platte oben) and an installation pipe M32 (available in every DIY store,). The installation pipe has an outer diameter of 32. 0 mm and an inner diameter of 28. 6 mm.
The length of the pipe depends on the height of the height stone. At 52 mm the height stone is 6 cm, at 72 mm it is 8 cm and so on.
If the ring for the tube is at the bottom when printing, no support is required.
The height stone consists of 3 parts, the plate at the bottom (Platte unten), the plate at the top (Platte oben) and an installation pipe M32 (available in every DIY store,). The installation pipe has an outer diameter of 32. 0 mm and an inner diameter of 28. 6 mm.
The length of the pipe depends on the height of the height stone. At 52 mm the height stone is 6 cm, at 72 mm it is 8 cm and so on.
If the ring for the tube is at the bottom when printing, no support is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
