Slicer Discord
GraviTrax Junior - go vertical – 3D-printbaar model van MakerWorld MakerWorld
Other Toys & Games

GraviTrax Junior - go vertical

676 Downloads
127 Likes
362 Makes
Model downloaden
In order to spice up GraviTrax Junior, I created a set of vertical drops, a catcher as well as a small and a big vortex to collect balls from multiple tracks. The drops can be stacked on top of big drop towers to adjust for height and air time. Without the catcher underneath, the vortices also work nicely as marble collectors. For the catcher, I wanted the arch to end right at the edge of the piece, so the marbles cannot roll back and get stuck inside. So it ended up being a 5x high part, whose design was highly inspired by Seppel's 5-Fach Höhenstein: https://www.printables.com/model/700671-gravitrax-junior-5-fach-hohenstein-high-stone His part also works perfectly as a see through drop tower as well as side drop-in part, especially if used together with his bridge: https://www.printables.com/model/702577-gravitrax-junior-brucke-bridge Printing instructions:0.2 mm, adaptive layer height (to get nice vortices)2 Wall loopsNormal support, on build plate only
Categorie
Other Toys & Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, Marble PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Highcooley publiceert ook op

32 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie