Thingiverse
Gravity Picture Holder
von mygadgetlife
6
Downloads
27
Likes
0
Makes
This picture holder uses a captive rod to trap the inserted photo or memo.
The model has in-built tabs for stability while printing - set your slicer to ‘No Brim’.
Print with 0.3mm layers for a faster print.
Post printing:
Trim the support tabs from the base.
Cut the internal rod supports with a craft knife.
Remove the sacrificial rod end piece - use needle nose pliers or prise loose with a small screwdriver.
The holder can be attached to surfaces with Blue Tak, Command Strips or double sided tape.
Holder is 100mm (4") long.
The model has in-built tabs for stability while printing - set your slicer to ‘No Brim’.
Print with 0.3mm layers for a faster print.
Post printing:
Trim the support tabs from the base.
Cut the internal rod supports with a craft knife.
Remove the sacrificial rod end piece - use needle nose pliers or prise loose with a small screwdriver.
The holder can be attached to surfaces with Blue Tak, Command Strips or double sided tape.
Holder is 100mm (4") long.
mygadgetlife veröffentlicht auch auf
24 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
