Thingiverse
Green Gas Nozzle Extender
by DurcoDuck
21
Downloads
19
Likes
0
Makes
Simple nozzle extender for green gas cans, to give you a little bit more reach with thicker magazine bases, tested to work with Matrix cans - will give you additional 1cm reach
Note: the green gas can end should be as close to 2.75mm as possible as any gaps will lead to gas escaping and wasted, since it only takes ~10 mins to print, please adjust and test your print settings/model to shrink any tolerances - the tighter the fit onto the can - the better
Printed 100% infill with 0.10 layer height, PLA+
Note: the green gas can end should be as close to 2.75mm as possible as any gaps will lead to gas escaping and wasted, since it only takes ~10 mins to print, please adjust and test your print settings/model to shrink any tolerances - the tighter the fit onto the can - the better
Printed 100% infill with 0.10 layer height, PLA+
DurcoDuck also publishes on
3 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!