Green Hill Zone - Hedgehog Loop

My hedgie's old generic exercise loop needed to be replaced. This was the natural solution. This was my first ever foray into 3d design and printing. Taught myself Fusion, borrowed a 3d printer from a friend. Lost an entire print because I used the wrong pause command to insert a magnet and the print just flat out wouldn't resume. Learned a lot! Files are included, though not plates. I struggled a lot getting some of these to print well, there was lots of trial and error with support types, air gaps, support geometry. Not for the faint of heart! Also had to use a dremel to make a couple minor adjustments after the fact: the wheel assemblies didn't have enough clearance to be pushed in, so I had to remove some material, but then they snapped in fine the hanging rings were an afterthought. If I did this again, I'd do it differently so they were incorporated better Uses the following hardware: M2.5 self-tapping screws: 6 x 10mm (wheels) 6 x 6mm (wheel brackets) 2 x 20mm (lower chassis con