Greenhouse Gutter Guard

I have a Vitavia green house which has built in guutters. The trouble is they collect leaves and foliage from the neighbours trees, which ends up in the water butt.

This thing is a gutter gaurd grill which clips into the gutter and stops stuff from getting in there while letting the rain flow in OK.

You do need quite a few of them to do the gutters (about a dozen each side, but they only take an hour or so to print and since I used PETG I am hoping they last a number of years.

I print top side down with no supports raft or brim.

I used the concentric infill for exterior infill which can be found on Simplify3D, as this dramatically cuts down the wear and tear on the printer compared to the normal rectilinear infill. I dont know if this is an option on other slicers but worth seeking out as the long thin infills work quite well that way.