Thingiverse
Грибы / Griby | keychain
door nakwada
1
Downloads
0
Likes
0
Makes
I recently discovered Грибы (Griby/Grebz), a Ukrainian rap band, and decided to create a keychain based on their logo.
Prints in place, recommended for dual material printers, or if you have a Palette/+/2
There is a version for single extruder printers, just use two processes as in Simplify3D, or pause and change filament.
Original is yellow, but can also be found in red, blue, ... whatever you fancy. Be creative :)
Check their music out: https://www.youtube.com/watch?v=m0-yYhLgp_I
Prints in place, recommended for dual material printers, or if you have a Palette/+/2
There is a version for single extruder printers, just use two processes as in Simplify3D, or pause and change filament.
Original is yellow, but can also be found in red, blue, ... whatever you fancy. Be creative :)
Check their music out: https://www.youtube.com/watch?v=m0-yYhLgp_I
nakwada publiceert ook op
9 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!