Slicer Discord
Grid Light - completely 3d printable – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Grid Light - completely 3d printable

91 Downloads
103 Likes
7 Makes
Zum Modell
This LED lamp is completely 3D printable! It is designed so that no single part needs support. You dont need any glue or screws, everything is hold in place by 3D printable clips.I power my lamp with a Node MCU and WLED. There are a lot of tutorials on how to do it so i wont cover this again here. Assembly guide:Print all parts:Grid Layer 1-772 transparent windows72 clipsGet your WS2811 or WS2812 pixel chain cut to a length of 31 pixels.Insert the clips into layer 1. As a hint: take some tongs to squeeze the clip a bit before trying to insert it, that way it fits easier and will still hold well!Insert the LEDs into the layer 1.Connect the layer 2 to layer 1, some force is needed, i 2 clamps to controll pressure better and worked on a flat, even surface.Repeat step 3-5 with the other grid layers.Connect your LED controller of choice to the leds.Connect the base part to the rest of the light.Insert the window parts, they fit right into place and need no glueing.There you go! Hope you had
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck · aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
200 mm (Groß)
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen