MakerWorld
Organizers
Model downloaden
Gridfinity 1U spacer/lid
15
Downloads
8
Likes
9
Makes
I have a bunch of gridfintiy rugged cases (like this), and I use them all the time to move stuff around. However, there was a problem: the cases were 6u in height, whereas all my screw bins were 5u. I tried a few tape solutions, but nothing worked. But then I realised, I just need a 1u tall gridfinity spacer, and it did not exist any so i made my own. The spacer is available in 1x1, 1x2, 1x3, 1x4. But if you need another size, just request it in the comments!
_tbf publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
