Gridfinity Adapter for Tesla Model S/X Console

What is this? Adapter to convert your Model S/X console to a 5x3 Gridfinity setup. Compatibility Tesla Model S console from late 2016 to late 2020 (before the 2021 refresh).Tesla Model X console from 2016 to late 2020 (before the 2021 refresh)No modifications to the console itself are needed - this is a slip fit and uses friction from the “ribs” where the cup holders would normally mount. InstructionsPrint the adapter and most likely the “post” risers. I used and recommend PETG as it handles heat better. ASA, ABS, Nylon or Polymaker HT-PLA (high temp PLA) will work well too. I recommend avoiding regular PLA.There are 6 half-moon “risers” that you insert into the bottom of the adapter (see the photos). Or, optionally, you can use M3 bolts (I used M3x6mm bolts). There are 6 other risers that have cut outs on their base that will straddle the raised lines in the rubber console mat. These risers go in the middle (4) and one each at the front and back of the adapter (again, see the photos).