Gridfinity Base for US General Series 3 Tool Boxes

This is a collection of Gridfinity base plates designed to fit the exact dimensions of the drawers in Harbor Freight's 27" US General Series 3 toolboxes. There are eight base plates that need to be printed. Note that the Left/Right Center base plate should be printed twice - one for each side. Each base plate is labeled on the bottom just to make it a bit easier to place in the proper spot when you might have a stack of plates that you printed. These fit snug with no room to move. If they seem to fit just a bit too tight, then check the top edges of the printed base plate. I found that the top layer of a couple “oozed” slightly past the wall of the print. If that is the case, simply scrape that bit away and it should help. The inside drawer dimensions (also pictured) are: 22 15/32 (22 ½) inches wide19 9/16 inches deep January 16, 2025 Edit - Added two additional print profiles. One for the left side and one for the right side. These are both 2mm smaller that what is in the orig