Gridfinity Bolt and Threaded Insert Organizer

This gridfinity organizer is intended for small bolts, washers, nuts and threaded inserts. All of the bins are blank so you can add your own labels to them and 2 blanks are included. Label step files need to be shrunken by ~0.2mm to fit within tolerances but the ones in the 3mf file are pre-shrunk. A 1x1 bin can fit a 30mm long bolt for larger sizes but will fill up fast if you have more than 10. Most smaller bolts easily fit into a 1x1 bin unless you have a lot of them All bins and baseplates use 6x3mm magnets to hold together. Only 2 is needed per 1x1 section if you want to save on magnets. Recommend buying a set of 300 magnets per 5x5 grid since 1 full 5x5 grid will need 200 magnets in total if filling each pocket. Some pockets may be loose so a drop of superglue can be used to hold the magnet in place. (recommend liquid instead of gel superglue for a better hold) Labels are printed at a much smaller 0.08mm layer height with the arachne wall generator. Without this the periods in th