Thingiverse
Gridfinity Caliper Stand
door hoco
99
Downloads
147
Likes
0
Makes
This 1x2 gridfinity module holds a digital caliper horizontally. It is stable even without a baseplate.
It is based on this model: https://www.thingiverse.com/thing:6074935
It prints without supports, but I recommend watching the first layer go down to ensure the circles around the magnets all stick as expected. Once the first layer is down the rest should print with no issues.
I sliced it for PLA with 0.2mm layers. If you reslice it, I recommend 3 perimeters and to print the outer layers first.
Based on the Gridfinity System from Zack Freedman: https://thangs.com/designer/ZackFreedman
https://www.youtube.com/c/ZackFreedman
License: CC BY-NC-SA 4.0 https://creativecommons.org/licenses/by-nc-sa/4.0/
#gridfinity
It is based on this model: https://www.thingiverse.com/thing:6074935
It prints without supports, but I recommend watching the first layer go down to ensure the circles around the magnets all stick as expected. Once the first layer is down the rest should print with no issues.
I sliced it for PLA with 0.2mm layers. If you reslice it, I recommend 3 perimeters and to print the outer layers first.
Based on the Gridfinity System from Zack Freedman: https://thangs.com/designer/ZackFreedman
https://www.youtube.com/c/ZackFreedman
License: CC BY-NC-SA 4.0 https://creativecommons.org/licenses/by-nc-sa/4.0/
#gridfinity
hoco publiceert ook op
121 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
