MakerWorld
Organizers
Model downloaden
Gridfinity PC4M10x1 holder
21
Downloads
9
Likes
14
Makes
This is a holder for PC4-M10 Bowden PTFE connector for a Gridfinity base plate. It has five slots, each threaded using M10x1mm spec, allowing you to securely screw in your PC4 connector. It will stay in place. If you have issues such as the threaded slot being too tight, you can use the X-Y compensation parameter in your slicer and set a value like “0.2” or “0.3.” Avoid scaling the model, as that will prevent it from fitting into the Gridfinity plate. Positive values in the X-Y compensation parameter will enlarge the holes while keeping the original model scale intact; negative values will reduce the hole size. There’s no need to edit the STL to adjust the hole size—the slicer should be able to handle it. Default print profile defines 0.08 layer height; but it should also work using 0.12 layer height. I didn't try other heights; if you'd like to experiment, please share your research results ;). I would appreciate if you rate the model if you find it useful!Boost MeShow your ap
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!