Slicer Discord
gridfinity pencil sharpener box – 3D-Druckmodell von Thingiverse Thingiverse

gridfinity pencil sharpener box

von Chemieju
112 Downloads
127 Likes
1 Makes
Zum Modell
This is my attempt at a #gridfinity pencil sharpener that collects the shavings.
The entire thing is 1x1x6u, the shavings box being a 5u gridfinity box itself.
I used a sharpener bought from HEMA, but I am not sure if it is a "standard" one.
It's about 9.5 x 14 x 25mm.
The lid needs to be printed upside down and does require support.
You can support-block the 2 small overhangs at the top, they bridged just fine for me.
To install the sharpener, remove the blade-screw, put it in and put the screw back.
If the snap fit is too tight, sand back the locking parts a hint.
Quelle
Thingiverse
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Hardware nötig
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 3/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
25 mm (Klein)
Nachbearbeitung
Schleifen, Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen