Gridfinity Tapcon Tool Organizer

I frequently use Tapcon concrete anchors at home for mounting just about anything to concrete walls (pre-cast or concrete block), but it was always a pain to track down the various drill sizes and driver bits needed. Additionally, there were more than a couple times that I would accidentally use the larger size drill bit and only realize my mistake when I tried to install the anchor and it just slipped in the drilled hole.These blocks each fit on a 1x3 Gridfinity footprint and include labeled dedicated spots for each tool required for installation (drill bits, the Torx bits for installing the countersunk fasteners, and a hex driver for the more common Hex drive fasteners). Each block is labeled with the corresponding fastener size which the tools should be used with.I left Gridfinity standard magnet holes in the corners of each block if you want to use them, but personally I never do.