Gridfinity TS80/TS80p and Tip Holder Boxes

Those 3x1 Gridfinity Boxes will either hold your TS80 or TS80p Soldering Iron and a Tip or just two extra Tips. Note that I redesigned the base of the Boxes to save some material. You should be able to print that without Support even if your Printer does not handle Bridges too well. Its in the end just on the Underside of an Organizer :) UPDATE 2022-12-29A new version of the Iron&Tip Box has been added to fit the TS80p. The TS80p is cone shaped at the top (finger grip part) and therefore comes with a larger diameter as its predecessor the TS80. The space needed to fit the new finger grip part has been accomodated in the design to fit the TS80p in both directions. To allow the larger finger grip to fit I had to fill in the base of the Box again. UPDATE 2022-12-23A new symmetrical version of the Boxes holding two tips has been added. It is the same Box but both Tips face the same direction.