Gridifinity Parametric Part Bins

Gridfinity Parts BinDesign NotesSeparating the bin and label to their own parts allows for adjusting the depth of the label without sacrificing usable volume of the bins. Wall thickness (t) of 0.8mm feels optimal, but you may want to increase this for extra rigidity on lager bins. The labels are designed to be removable so you can swap them in and out as needed. Using a pair of tweezers or a small flathead, you can disengage the tabs as shown below. When the bin's width is larger than 1, you can change the label parameter to set the snap point location:0 = left1 = center2 = right PrintingMake sure to split the part into separate objects before printing, the top face of the label should be on the plate's surface. I've been printing these with PETG on a 0.6 nozzle @ 0.3mm layer heights for f