grinder holder

This is a grinder holder I designed to keep grinders off the table and displayed nicely, within reach, on the wall. These were originally made for a specific grinder, but adjusted to work fine with a few of my other grinders. These are meant to have a strong grip with a nice satisfying “smack” once it’s pushed in and pulled out. Alternatively, if you prefer not to push your tools into holders, you can drop it in from above. This allows the smaller diameter base of the grinder to easily slide in until the wider section sits on the print. This helps ensure it's placed properly and won't fall out due to insufficient placement. I prefer my holders very strong, so I typically go with higher infill and wall counts to ensure the tool is placed securely. You can also use less walls and lower infill if you want a slight “adjustability” with the print. These settings allow the material (presumably PLA in this case) to flex a little to fit your tool. Both profiles are included (strong & “