Thingiverse
Grinder M12 axis Extension
von Seb_opticien
7
Downloads
7
Likes
0
Makes
I'm an optician and I make some custom frames in my store.
For that purpose, my podiatrist neighbour give me his former grinder (Brand Creusen, 650W 220V).
For my work, i need to adapt lages polishing wheels (~40mm large for 200 to 250mm diameter) and the curent thread are little too short for that. Actually, i use my cord drill and some M12 screw.
The extension may need some reinforcement with m6 thread rod and 2 nuts.
Also, i didn't threaded the M12 inside the extension, and intended to do that directly on the grinder (and I don't have a ccw Tap)
The knob i made need to be scale (and reverse) on X and Y to 110/120%. Z scale at 100%.
For that purpose, my podiatrist neighbour give me his former grinder (Brand Creusen, 650W 220V).
For my work, i need to adapt lages polishing wheels (~40mm large for 200 to 250mm diameter) and the curent thread are little too short for that. Actually, i use my cord drill and some M12 screw.
The extension may need some reinforcement with m6 thread rod and 2 nuts.
Also, i didn't threaded the M12 inside the extension, and intended to do that directly on the grinder (and I don't have a ccw Tap)
The knob i made need to be scale (and reverse) on X and Y to 110/120%. Z scale at 100%.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
