Thingiverse
Grip Trainers (Crimp)
von Johnrmac
98
Downloads
77
Likes
0
Makes
Printed at .32mm with 4 perimeters and 10% infill.
Need to be tied with paracord like shown in the picture or their weight capacity is significantly reduced.
Its been tested with 250lbs on one handle, but to play it safe, I'd suggest a weight limit of 200lbs.
Not to be sold or reproduced :)
Full project here: https://youtu.be/Bzyx05J8IDU
Need to be tied with paracord like shown in the picture or their weight capacity is significantly reduced.
Its been tested with 250lbs on one handle, but to play it safe, I'd suggest a weight limit of 200lbs.
Not to be sold or reproduced :)
Full project here: https://youtu.be/Bzyx05J8IDU
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
