Thingiverse
Groove mount adapter
por Gormadt
15
Descargas
14
Likes
0
Makes
This is a groove mount adapter that fits into the Titan extruder to mount it to a CR10 V2 or V3
The threaded bit is an M10x1 that is 8mm long
It screws right into the top of the hot end to mount a titan extruder
Print with at least 0.15mm layer height if not finer
Also print it thread side up and you shouldn't need supports
The threaded bit is an M10x1 that is 8mm long
It screws right into the top of the hot end to mount a titan extruder
Print with at least 0.15mm layer height if not finer
Also print it thread side up and you shouldn't need supports
Gormadt también publica en
22 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
