Grove Temperature Sensor Case for Seed Studio - WIO Link

This 3D model is a case for the Grove temperature and humidity sensor which works with Seed Studio's WIO Link product. It is a two part case that includes a base that the sensor can be screwed to with 3 small fasteners and a lid that snaps in place.

The lid has two rectangular holes to accommodate the sensor device on the PCB assembly and the cable connector. If I were to make any modifications to the model, I would adjust the rectangular hole in the lid to better accommodate the sensor.

This model has been printed on a Makerbot Replicator+ with PLA filament. A raft was used because it is recommended for the Replicator+. Other printers would not require a raft. 5% infill was used and that seemed to be adequate.

This case is a remix of the "Grove Sensor Mount - Large" model that was published by Ccirone2, on Mar 9, 2017.