Slicer Discord
Growler Saver – 3D-printbaar model van Thingiverse Thingiverse

Growler Saver

door Ductsoup
17 Downloads
10 Likes
0 Makes
Model downloaden
Growlers are awesome. Instead of recycling beer cans or bottles you take your growler to your favorite brew pub to get it refilled over and over again. Not saying that recycling bottles or cans is bad, just that bypassing the whole recycling thing all together is even better. Besides, fresh beer on tap is always better than canned or bottled.

I am fortunate to live near several craft breweries so I always keep a couple empty growlers in the car in case I have the opportunity to stop by and get them filled with an interesting and/or delicious brew.

The problem is that, over time, bouncing around in the car the ceramic will tend to chip the glass so they won't seal anymore. At that point you have to buy a whole new growler which defeats the point and costs money. If you close the cap it won't chip but, it'll shorten the life of the seal and if there's any moisture trapped inside critters will likely grow and spoil your delicious beverage.

This is a vented protective cap to exte
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie