Growth chart router template

Router template to be used to make a ruler style growth chart.

I used PLA at 15% infill which should hold up for a couple uses. If you use clamps to hold the template down, then you will need to reposition the clamps in order to be able to reach all of the inch marks. I didn't try to use double sided tape, but I'm sure that it would be easier than having to move around clamps.

The template allows you to add the numbers above or below the foot line.

Note: The top half will always be above the bottom half when moving the template along the board. The inch marks are 1/2" wide. I used a 1/4" bit with a 5/16" bushing.