GS500 Headlamp Bracket

The last picture shows the bracket installed but that was my test piece which had very little infill.

I sourced this file from opl1 off printables

https://www.printables.com/model/517586-gs500-e-adapter-for-univeral-7-headlights/files

I adjusted was the height of the model because i found that the headlight sat to far into the bezel

I also added the tab for the adjuster screw so it allows for the aftermarket 7" Led headlamp to be installed in the factory GS500E headlight pod without twisting in place.

I have printed mine in pla with 6 walls and 60% infill in hopes that it will keep its shape. If not i will re print in a more appropriate materiel.

The middle is a little tight on the headlamp i was using but was able to sand down the middle a little to be able to force it onto the assembly.