GT86 Center Console Push Start Mount

A solution for relocating the push button start to the recessed area in the center console. If you don't have heated seats this is just a blank area. Some people put decorative plates here but this is a more purposeful use of the space. This also allows you to swap out the cubby for the extended one without the push button.

Make sure to print in a material that can handle the heat of a vehicle in the sun. In my experience, PLA does not do well in a hot car. I used TPU for my print. ABS or PETG would work well too.

Print the drill template and remove your center console. Use the drill template to drill the five 3mm holes in the center console. The four in the corners will be used to mount the final piece. The center hole is a pilot hole for a hole saw. Use a 2 1/8" hole saw to cut a large hole in the center of the recessed area.

Now print the actual push button mount. Insert four M3 countersunk screws into the recessed holes in the corners. Use epoxy and/or nuts on the backside