GU10_Socket_Adapter/Extension

GU10 Socket Adapter/Extension


I designed this, because the replacement light for my lamps are very expensive and of special size. No "normal GU10 Light" fits in the Lamp Socket.
One original light cost about 25€ - the Replacement LEDs about 3€ per pcs



The two holes need to be drilled through (2,5mm drill) - therefore, no support is needed (which would be difficult to remove)

You also need 2x M3x10 Screws.

1. Print
2. Drill through the holes , 2,5mm drill
3. insert the GU10 Socket Light | fits very tight ! - Insert and remove a few times
4. Screw the 2x M3x10 Screws in

!!! WARNING !!!
USE AT YOUR OWN RISK
ONLY USE THIS WITH LIGHTBULPS/SPOTs THAT WONT GET HOT AND DONT DRAW HIGH CURRENT !!!!!
i use them with 3.5W LED Spot