Thingiverse
Guild Wars 2 Bookend
von MarcusPfeiffer
12
Downloads
11
Likes
0
Makes
3 Part bookend for fans of the game, Guild Wars 2.
Print the logo in a different colour than the rest of the bookend.
The tongue and logo don't need support or brims. I always do a skirt line so that the filament is working nicely before the main components are printed.
The main "GW2 Book End - base" file should have Support "touching build plate" only set, and that at only over 80 degrees so that it only supports one line of necessary overhang at the union between the base and the tongue.
Everything fits nicely together but you'll need two little screws underneath to keep the tongue attached.
I have infill set at 20%.
Print the logo in a different colour than the rest of the bookend.
The tongue and logo don't need support or brims. I always do a skirt line so that the filament is working nicely before the main components are printed.
The main "GW2 Book End - base" file should have Support "touching build plate" only set, and that at only over 80 degrees so that it only supports one line of necessary overhang at the union between the base and the tongue.
Everything fits nicely together but you'll need two little screws underneath to keep the tongue attached.
I have infill set at 20%.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
