Guitar Amp Channel Switch

This is a foot switch case for an Orange Amp to switch between channels, my specific Amp is the "Orange Crush 20", I have not tested this switch with other Amps, so handle with care with other Amps. For the Orange series the switch will work I have printed the case in PLA-CF from Bambulab and it printed extremely well. Printed on the Textured PEI Plate . For the wiring it is just a simple switch and a LED between the +5V and GND wires hooked up to a 6.3mm audio jack. Pay attention to the polarity of the LED. you will need:4x threaded insert for M3 by 4mm4x countersink screws M4 x 6mm1x 6.3 mounting jack socket mono (you don't need one with a switch terminal)1x foot switch1x LED 5mm for 5Volts (any color will do)1x resistor 150 Ohm+ some thin wires the LED socket is also printed you can find the model here: Socket for 5mm LED