Thingiverse
Guitar hanger
von LFlab
2
Downloads
1
Likes
0
Makes
I made this to hang my guitar on an overhanging wall. Added a bit of felt to the lower bracket to protect the guitar.
An M5 insert is pressed into the top bracket (I used a Ruthex insert), and a piece of brass is used as a gate to hold the neck in place (should really also have a bit of felt to protect the strings.
It was modeled in Creo v4.
(I have since replaced the little ruler with a piece of brass :-) )
An M5 insert is pressed into the top bracket (I used a Ruthex insert), and a piece of brass is used as a gate to hold the neck in place (should really also have a bit of felt to protect the strings.
It was modeled in Creo v4.
(I have since replaced the little ruler with a piece of brass :-) )
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
