Thingiverse
Guitar Holder
von Felix_Yang
5
Downloads
2
Likes
0
Makes
Hi everyone, I designed this guitar holder so that I can hang my guitar which weighs 4.3 lbs on the wall.
No screw is needed so no worries for damaging the wall! Simply buy a 3M damage-free adhesive stripe and stick it at the back of the transverse beam (bot the X-looking structure). Make sure that the stripe's instruction tells you the max load the adhesive layer can take(I used the one that takes up to 5 lbs). Mine has been used for almost a month and never been loose.
The most narrow area on my guitar where it touches the hanger is 45mm.
Hope you like it, enjoy :)
No screw is needed so no worries for damaging the wall! Simply buy a 3M damage-free adhesive stripe and stick it at the back of the transverse beam (bot the X-looking structure). Make sure that the stripe's instruction tells you the max load the adhesive layer can take(I used the one that takes up to 5 lbs). Mine has been used for almost a month and never been loose.
The most narrow area on my guitar where it touches the hanger is 45mm.
Hope you like it, enjoy :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!