Thingiverse
Guitar holder
von Plus1_Man
4
Downloads
6
Likes
0
Makes
Simple Guitar holder printed in PLA plus. I printed it with 0.8mm walls and 30% infill and it holds easelly 50kg. I placed a piece of wood on the back, so that the guitar stays away from the wall and just hangs in the air. The space between the two supports is 50mm, so it should hold every standart guitar. The holes are 4,5mm in diameter an 40mm apart. Enjoy!!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
