Thingiverse
Music
Zum Modell
Guitar Nut
12
Downloads
25
Likes
1
Makes
I printed this on my Ender 3 pro at 100% infill.
You may need to run a file over the grooves if you are using larger strings or want the strings to sit closer to the fret board.
It was designed for a student guitar at 42mm wide but should scale up fine
You may need to run a file over the grooves if you are using larger strings or want the strings to sit closer to the fret board.
It was designed for a student guitar at 42mm wide but should scale up fine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
