Guitar Pick Case

Design ConceptThis guitar pick case holds seven standard guitar picks. The base has seven slots that set 0.85 inches deep allowing enough of the pick exposed for easy extraction. The lid has a light tread plate design to allow for good grip to remove the top from the bottom. There is a extrusion on the lid that mates with a divot on the lid to hold it in place and keep the top from easily sliding off. The text reading " Guitar Picks" is debossed .04" for clarity. There is a fuzzy skin detailed applied to both the holder and the lid for a professional look and make layer lines less obvious.PurposeThis guitar pick case allows you to keep your guitar picks in one place and easy to get. Drop a pick on the floor and you will see they are not the easiest to pick up. This keeps the guitar picks together and easy to access. You can also keep track of your picks while you venture from place to place.Printing RecommendationsI try to use PETG for about everything now. I like the physical properties better than PLA but it should work fine with this component.Assembly InstructionsBe sure that you orient the top in the correct direction when placing the top. The divot is only on one side of the lid and the extuded piece that rests in the divot is only on one side.