Guitar Slide Holder

This is a guitar slide holder that can either sit on the table or placed on a music stand post. The posts are also good for holding thumb and finger picks.

hole: 19.5 mm, but it would be little trouble for me to make a few variations
fill: standard fill 15%
perimeters: 3
post reinforcement bolts: 3mm. (important!)

v7 - 1 piece. Choose this if you can take your stand apart on top and just slide it on
v8 - 2 piece(print 2). you WILL have to sand/file this to get it to fit. DON'T force or you won't be able to get it apart
v9 - 2 piece(print 2) with looser tolerances. You'll probably have to glue this together
Note: you can also mix and match v8 and v9. If v8 ends up way too tight, print a v9 and see how it fits with a v8.

NOTE: If I were to do this again I would have the two halves bolt together. The tolerances of 2 interlocking parts is problematic.