Music
Go to Model
Guitar Strap Shortener
7
Downloads
12
Likes
0
Makes
I designed this because my daughter wanted this awesome guitar strap for her Ukulele, but it was too large to effectively hold it at the right height. Usually people double over the strap and duct tape it or use clips to solve the problem, but I found that my daughter's hair kept getting stuck in those solutions.
With this strap shortener, you can take some of the slack out while avoiding the problems with tape. Once printed, grab a couple self-tapping screws from your hardware store and some washers and you'll be rocking out in no time!
With this strap shortener, you can take some of the slack out while avoiding the problems with tape. Once printed, grab a couple self-tapping screws from your hardware store and some washers and you'll be rocking out in no time!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!