Guitar Wall Mount

Simple guitar wall mount I designed - I hope you enjoy! A few notes on this model… I printed mine using PLA and they've held up fine for several months as of this posting - no sagging or falling off the wall. However, I have NOT tested the maximum weight capacityI haven't had any issues with the mounts scratching my guitar necks. However, if that is a worry for you, I'd suggest gluing some felt to the inside of the mountI would highly recommend using washers as shown in the photo below to prevent damage to the plastic when tightening. Tighten until the back of the mount is flush SNUGLY against the wall - not too tight, as this may damage the mount