Gunpla Runner Stand - Hex

Introducing the Foldable Print in Place Gunpla Runner Stand (a mouthful I know!). This is the Hex pattern version. Make sure to check out the plain pattern here: https://makerworld.com/en/models/250739#profileId-267023 Decided to give myself a bit of a challenge in designing something that's both print in place and with some form of hinge. The model was inspired by the MGEX Strike Freedom paper runner stand and consists of a simple hinge design based on Nokiri's ribbon fidget toy. There's a catch on the bottom of it to prevent it from opening/folding back out from gravity. When taking it off the build plate, grab each hinge and give it a slow bend to loosen each segment. Going hard off the bat may cause it to disconnect Make sure to follow my page for upcoming variants of this model, and please leave a comment and photo of your new prints!