Thingiverse
GWS 360 Servo Tilted Camera Mounts
door StuntDouble
7
Downloads
8
Likes
0
Makes
This thing is a set of tilted camera mounts for a GWS 360 degree sail winch servo. The mounts attach directly to the servo spline and they are suitable for a camera such as the GoPro Session or Runcam HD. The mounts are available with a 5 or 10 degree tilt. Cameras are attached to the mounts using zip-ties.
Note that this design is for the GWS sail winch servo with a 25 tooth spline (there is an older version with a 23 tooth spline)
It is important to print these mounts so that they attach to the servo with a tight secure fit. Adjust the print scale to find the best fit. For example I have been using the same brand of PLA for a while then recently I used a different brand and found the scale had to be reduced to 0.96% for a snug fit.
It is recommended to print the mounts upside-down with the spline attachment facing upwards. This will guarantee the teeth are printed accurately. Support material will need to be added when printing upside-down.
Note that this design is for the GWS sail winch servo with a 25 tooth spline (there is an older version with a 23 tooth spline)
It is important to print these mounts so that they attach to the servo with a tight secure fit. Adjust the print scale to find the best fit. For example I have been using the same brand of PLA for a while then recently I used a different brand and found the scale had to be reduced to 0.96% for a snug fit.
It is recommended to print the mounts upside-down with the spline attachment facing upwards. This will guarantee the teeth are printed accurately. Support material will need to be added when printing upside-down.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!