Thingiverse

Gyro Eval Board Holder

von M_G

3 Downloads

0 Likes

0 Makes

This OpenSCAD script creates a holder for an STM Gyro Eval Board that fits onto the moutign holes on a Gyro_Turntable_Mounting_Plate so that it can be tested on a high speed turntable

Note:
may need to trim some stuff from the top of the cylindrical posts as there are many small components adjacent to the screw holes

Changes from previous versions:
v0.4
- removed one of the bolt holes under devices
- make it thicker (from 3 to 5 mm) so it prints better
v0.3
- adjusted some values based on callipers based measurements of board
- now it should be realistically sized
v0.2
- removed junk lines
- added cutouts
- repositioned parts
- added minkowski sum to round out corners under PCB
- made it into a printable item
v0.1
- first attempt at laying out parts

3D electronics experiment gyro gyroscope holder IMU Inertial Measurement Unit makerbot model mount openscad parametric part prototype tool tyndall useful WIMU

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat