Thingiverse
Gyro maze
door JustinSDK
1.8k
Downloads
1.6k
Likes
11
Makes
[](https://www.youtube.com/watch?v=7Y0FvOO9MaM)
This is based on [Maze circle generator](https://www.thingiverse.com/thing:1255574). You may change the following parameters to generate a maze gyro, different every time:
- `radius`
- `spacing`
- `wall_height`
- `wall_thickness`
- `cblocks`
- `rblocks`
- `ring`
You may roll it on 720 degrees. This may resemble new mazes on both sides. It always makes me think of a movie "Maze Runner".
To avoid overlapping between rings, you may try different values of the `spacing` parameter. The 0.6 mm `spacing` is suitable for my printer with 0.2 mm layer height and 0.6 mm Bottom/Top thickness. Although 0.6 mm `spacing` seems suitable for most situations, I think it's different for different 3DP, filaments and settings. That's why I makes the `spacing` parameter changeable.
- *[OpenSCAD Documentation - Traditional Chinese](http://openhome.cc/Gossip/OpenSCAD/)*
- *[OpenSCAD Documentation - English](http://openhome.cc/eGossip/Open
This is based on [Maze circle generator](https://www.thingiverse.com/thing:1255574). You may change the following parameters to generate a maze gyro, different every time:
- `radius`
- `spacing`
- `wall_height`
- `wall_thickness`
- `cblocks`
- `rblocks`
- `ring`
You may roll it on 720 degrees. This may resemble new mazes on both sides. It always makes me think of a movie "Maze Runner".
To avoid overlapping between rings, you may try different values of the `spacing` parameter. The 0.6 mm `spacing` is suitable for my printer with 0.2 mm layer height and 0.6 mm Bottom/Top thickness. Although 0.6 mm `spacing` seems suitable for most situations, I think it's different for different 3DP, filaments and settings. That's why I makes the `spacing` parameter changeable.
- *[OpenSCAD Documentation - Traditional Chinese](http://openhome.cc/Gossip/OpenSCAD/)*
- *[OpenSCAD Documentation - English](http://openhome.cc/eGossip/Open
JustinSDK publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!